簡體 繁體 english menu
  • ABOUT
  • Products
    • Home Installation
      • Multi-Room Amplifier
      • Power Amplifier
      • Media Player
      • Power Management
      • Solution Boxes
      • Speaker Selector
      • Speaker
    • Intelligent Conference
      • Power Amplifier w/Dante Interface
      • Two Channel Power Amplifier
      • Digital Speaker Management
    • Public Address
      • Amplifier
      • Speaker Selector
      • Dante
      • CSP Transceivers
      • CSP Receivers
      • Solution Boxes
    • Pro Audio
      • Mixer
      • Headphone Amplifier
      • Guitar Tool
      • Mini Mixer
      • Direct Box
      • Mic Preamp
      • Phantom Power Supplier
      • Other Solution
  • NEWS
  • SERVICES
  • CONTACT
UP1812A





In Wall Audio Power Amplifier




UP1812A


In Wall Audio Power Amplifier

UP1812A module is Class D power amplifier with volume control on the front panel, connecting with CSP transceivers and receiving the audio signal from pair B and C of UTP RJ-45. When the volume control is set to minimum, the UP1812A will go to standby mode. The output and power in terminal is designed at the back panel, and allows to connect with 4 Ohm or 8 Ohm loudspeaker.
 
UP1812A module could be powered from a 24VDC power supply by using the rear panel terminal block, or powered from the connected CSP transceiver module.

The power also could be provided to all the connected modules by Pair D of UTP CAT5 cable. 

Features

•3.5W(8 Ohm) Class D Amplifier with Volume Control
•Speaker Output on Rear Panel
•Activates Standby Mode by Setting Level to Minimum
•Volume Level Adjustment on the front panel
•Accepts Input Signal from RJ45 jack
•Connects to CSP Transceiver using UTP Cable
•Powered from CSP Transceiver or 24VDC input
•Thermal and Short-Circuit Protection

Specifications

•Input: CSP UTP RJ45
•Connection: RJ45
•Twisted Pair Used: B, C pairs
•Output Power: 3.5W/8Ohm; 6.5W/4Ohm
•THD+N: < 0.1% (@1KHz, 1W)
•Frequency Response: 50 Hz ~ 20 KHz
•Noise: <-70dB ( <1W RMS)
•Output Connector: Detachable Terminal Block
•Power Requirement: 24 VDC @ 55 mA; 155 mA (Max.)
•Power Consumption: 215mA (3.5W/8Ohm); <0.3W (Standby mode)
•Dimensions: 43mm x 66.5mm x 40mm (WxHxD)

Documents